Use and Care Manual

REMOVING THE CHUCK (FIG. 14)

1. Turn the feed handles to lower the chuck to the lowest position.

2. Slide the drift key into the opening in the quill. Tap on the drift key

using a hammer (not included). The chuck and arbor will drop out.

NOTE: To avoid possible damage to the drill or chuck, be prepared to

catch the chuck as it falls. As a safeguard, the table can be raised to

its maximum height as a backup in case you miss the falling chuck.

ADJUSTMENTS

To adjust the height of the drill press table, loosen the table locking

handle (Fig. 15 - 2) and turn the table adjustment crank (Fig. 15 - 1).

To bevel the table in either direction, loosen the hex bolt located un-

derneath the table (Fig. 16 - 1). Bevel the table in either direction (Fig.

17). Once the desired position has been achieved, retighten the hex

bolt (Fig. 16 - 1).

To swing the table around the column, loosen the locking handle (Fig.

15 - 2) and swing the table and the rack into the desired position (Fig.

18). Retighten the table locking handle once the desired position has

been reached.

ASSEMBLY & ADJUSTMENTS

Fig. 14

Fig. 15

Fig. 16 Fig. 17 Fig. 18

Drift

Key