Use and Care Manual

ASSEMBLY (CONT.)

8. Assemble the hub cover (Fig. 9 - 1) and fasten it in

place with a M6x16 ﬂat head screw (Fig. 9 - 2). Attach the

three handle caps (Fig. 10 -1).

9. To install the LED light assembly, connect the lamp

plug contact (Fig. 11 - 2) to the power source plug con

tact (Fig. 11 - 3) within the drill’s head.

10. Use four pan head screws (Fig. 11 - 1) to install the

lamp assembly on the drill press head. Flip the LED lamp

switch (Fig. 11 - 4) to check if the lamp is working prop

erly.

INSTALLING THE CHUCK

Before installing the chuck and arbor to the drill press head, clean the surfaces with a non-petroleum

based product such as alcohol or lacquer thinner. Any oil or grease must be removed, otherwise the

chuck runs the risk of coming loose during operation.

1. Push the arbor (Fig. 12 - 1) onto the spindle.

2. Push the chuck (Fig. 12 - 2) onto the arbor.

3. Using a wood mallet (not included), ﬁrmly tap the chuck upward into position on the spindle shaft

(Fig. 13).

ASSEMBLY & ADJUSTMENTS

Fig. 9

Fig. 10 Fig. 11

Fig. 12 Fig. 13