Use and Care Manual

ASSEMBLY

1. Position the base on the ﬂoor. Attach the column to the

base using four M10x30 hex head bolts (Fig. 2).

2. Loosen the set screw (Fig. 3 - 1) and remove the col-

umn collar (Fig. 3 - 2) and gear rack (Fig. 3 - 3) from the

column. With the help of a friend, place the rack inside the

table bracket before sliding the table assembly (Fig. 3 - 4)

with the rack down onto the column. Place the column

collar down over the rack after positioning the rack and

the table in place. Tighten the collar’s set screw with a hex

wrench to hold the rack into position.

3. Install the table adjustment crank (Fig. 4 - 1). Secure

it in place by tightening the set screw (Fig. 4 - 2). This

handle will control the height of the drill press table.

4. Screw the table locking handle into position (Fig. 5 - 1).

Tightening this handle prevents the table from swivelling

and having its height adjusted.

5. Install the head assembly with the help of a friend by

carefully lifting the head above the column. Slide it onto

the column, making sure the neck goes down as far as

possible (Fig. 6).

6. Align the head with the base so they are parallel with

one another and facing the same direction. Tighten the set

screw (Fig. 7 - 1).

7. Install the feed handles (Fig. 8 - 1) into place using

three M8x12mm socket head screws (Fig. 8 - 2).

ASSEMBLY & ADJUSTMENTS

WARNING: If any part is missing or damaged, do not plug the drill press in until the missing

or damaged part is repaired or replaced.

Fig. 2 Fig. 3

Fig. 4

Fig. 5

Fig. 6 Fig. 7

Fig. 8