Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

WARNING: If any part is missing or damaged, do not plug the drill press in until the missing or damaged

part is repaired or replaced.

The column assembly (column, column support, rack, rack collar,

and table support bracket) must be attached to the base. The table

and table support handles must be attached to the table support

bracket. The motor housing must be attached to the column.

Tools needed for assembly

• Adjustable wrench

• screwdriver

• Hammer and block of wood

COLUMN ASSEMBLY TO BASE (Fig. 3)

1. Place the column tube (1) on the base (2), aligning the column

support holes to the base holes.

2. Install a hex head bolt (3) in each column support hole and

tighten bolts using the adjustable wrench.

TABLE TO TABLE SUPPORT BRACKET (Fig. 4)

1. Place the crank handle (1) onto the shaft (2) of the table bracket

so the flat of the shaft is under the set screw (3). Tighten the set

screw.

2. Thread the table lock handle (4) into the front of the table sup-

port bracket.

3. Thread the table support lock handle into the rear of the table

support bracket (not shown).

4. Position the table (5) in the same direction as the base. Install

the table and tighten the table lock handle (4) and support lock

handle.



Fig. 3

Fig. 4