Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

UNPACKING (Fig. 2)

Unpack the drill press and all of its parts. Compare against the list below. Do not discard the carton or any pack-

aging until the drill press is completely assembled.

To protect the drill press from moisture, a protective coating has been applied to the machine’s surfaces. Remove

this coating with a soft cloth moistened with kerosene or WD-40®. Do not use acetone, gasoline, or lacquer thin-

ner to clean. Apply a coat of good paste wax to the table and column. Wipe all parts with a clean dry cloth.

Head/Motor Assembly

Column Assembly

Table

Base

Hex Keys - 3, 4, 5

Table Support Lock Handle

Table Lock Handle

Bolt M12 X 35

Chuck

Chuck Arbor

Chuck Key

Feed Handle

Speed Handle

Wedge

Crank Handle

Fig. 2