Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

RAISE OR LOWER THE TABLE (Fig. 11)

1. Loosen the support lock handle (1) and turn the crank handle (2)

until the table is at the desired height.

2. Tighten the support lock handle before drilling.

ROTATE THE TABLE (Fig. 11)

1. Loosen the support lock handle (1) and turn the table around the

column to the desired position.

Note: The rack should rotate around the column with the table sup-

port bracket. If the rack binds and does not rotate, slightly loosen

the set screw in the rack collar.

2. Tighten the support lock before drilling.

TILT THE TABLE (Fig. 12)

1. Rotate the table clockwise with the fork wrench. Pull out the loca-

tion pin. Put the location pin and nut in suitable area.

2. Rotate the bolt (1) counterclockwise with a wrench to loosen it.

3. Adjuste the angle of the table.

4. Tighten the bolt with fork wrench.

ADJUST THE TABLE TO BE HORIZONTAL

1. Rotate the bolt (1) counterclockwise with a wrench to loosen it.

2. Rotate the table to 0˚.

3. Hit the location pin (2) into the location hole in the table support

with a hammer.

4. Tighten the nut of the location pin (2) slightly.

5. Lock the bolt (1) with wrench.

Fig. 11

Fig. 12