Manualshelf

Use and Care Manual

ManualsBrandsWEN ManualsDrill Presses3.2 Amp 10 in. 5-Speed Cast Iron Benchtop Drill Press with Laser and 1/2 in. Keyless Chuck
11121314151617181920
12
ASSEMBLY AND ADJUSTMENTS
INSTALLING LASER BATTERIES (PRE-INSTALLED)
1. Turn off the drill laser.
2. Pull the tab located below the laser switch and lift up the laser switch cover (Fig. J).
3. Install two AAA batteries into the battery slots and close the switch cover (Fig. K).
RAISE OR LOWER THE TABLE
1. Loosen the table locking handle and turn the crank handle until the table is at the desired height (Fig. L).
2. Tighten the table locking handle before drilling.
Fig. K
Fig. J
Fig. L