Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

ATTACHING COLUMN ASSEMBLY TO BASE

1. Place the column tube on the base, aligning the column support holes

to the base holes.

2. Install a hex head bolt in each column support hole and tighten bolts

using an adjustable wrench (not included).

ATTACHING TABLE TO COLUMN

1. Loosen set screw (Fig. B - 1) in rack collar (Fig. B - 2) and remove the

collar from the column.

2. Remove the rack (Fig. B - 3) from the column.

3. Placing the rack into the table bracket, slide the table assembly with

rack down directly onto the column (Fig. B). The longer edge of the

rack without gear teeth should be towards the top of the drill press.

4. Place the column collar down onto the rack and tighten the set screw

with the smaller hex wrench to hold the rack in position.

4. Insert the table adjustment shaft (Fig. C - 2). Align the socket-head set

screw (Fig. C - 3) on the handle with the flat of the adjustment shaft.

Using the larger hex wrench, tighten the set screw.

5. Position the table directly over the base, and tighten the table locking

handle (Fig. D - 1) to secure table assembly.



Fig. A



Fig. B

Fig. C



Fig. D