Use and Care Manual

UNPACKING

Unpack the drill press and all of its parts. Compare against the list below. Do not discard the carton or any

packaging until the drill press is completely assembled.

To protect the drill press from moisture, a protective coating has been applied to the machine’s surfaces. Remove

this coating with a soft cloth moistened with kerosene or WD-40®. Do not use acetone, gasoline, or lacquer

thinner to clean. Apply a coat of good paste wax to the table and column. Wipe all parts with a clean dry cloth.

WARNING: If any part is missing or damaged, do not plug the drill press in until the missing or

damaged part is repaired or replaced.

The column assembly (column, column support, rack, rack collar, and table support bracket) must be attached to

the base. The table and table support handles must be attached to the table support bracket. The motor housing

must be attached to the column.

Tools needed for assembly (not included):

• Adjustable wrench

• Hammer and block of wood, or rubber mallet, or dead-blow hammer

ASSEMBLY AND ADJUSTMENTS

Head/Motor Assembly (1)

Base (1)

Table Locking Handle (1) (with table)

Table Assembly (1)

Table Adjusting Handle (1)

AAA Batteries (2) (inside head)

Chuck (1)

Chuck Key (1)

Feed Handles (3)

Hex Wrench (2)

Hex Head Bolts (4)

Column Assembly (1)

(with rack and rack collar)

