Use and Care Manual

ASSEMBLY AND ADJUSTMENTS

FEED DEPTH ADJUSTMENT

1. Loosen the depth locking knob (Fig. P - 1).

2. Turn the depth scale ring (Fig. P - 2) to the desired

depth.

3. Lock the scale ring in place by tightening the depth lock-

ing knob.

SPEED ADJUSTMENT

For a video demonstration using the WEN 8-Inch Drill

Press, visit http://bit.ly/1LGcLIb

1. To change to another one of the five available speeds,

open the belt housing cover and loosen the belt tension

locking knob found circled in Fig. Q.

2. Pull the motor towards the front of the press and tighten

the belt tension locking knob. Adjust the position of the

belt on the belt pulleys.

NOTE: Ensure that the belt runs on the same setting of

each pulley (e.g. if the belt is on the third setting of the mo-

tor pulley, it should be on the third setting of the spindle

pulley as well).

Fig. P



Fig. Q

3. Loosen the belt tension locking knob and push the motor towards the rear of the drill press, ensuring that the

belt is under tension. Tighten the belt tension locking knob. Close the belt housing cover.

CHANGING THE LIGHT BULB

To change the light bulb, turn off and unplug the machine. Turn the old bulb counter-clockwise to remove it, and

screw in the new bulb. You may then plug in and restart the machine.

NOTE: do not install a bulb rated higher than 60W. Replacement bulbs can be ordered from wenproducts.com

by searching part number 4210B-086.