Use and Care Manual

1010

ASSEMBLY AND ADJUSTMENTS

DRILL PRESS HEAD TO COLUMN (Fig. E)

CAUTION: The drill press head is heavy. To avoid

injury, two people should lift it into position.

1. Carefully lift the drill press head assembly and position it over the

column (Fig. E).

2. Place the mounting opening on the drill press head over the top of

the column. Make sure the drill press head is seated properly on the

column.

3. Align the direction of the drill press head with the direction of the

base and the table.

4. Tighten the set screw using a hex wrench (Fig. F).

FEED HANDLES (Fig. G)

1. Insert the three feed handles into the threaded openings on the feed

hub (Fig. G - 1).

2. Manually tighten the handles into the openings. If desired, use the

adjustable wrench to grip the flats of the feed handles and fully

tighten them into the feed hub.

NOTE: When using the drill press, one or two of the feed handles

may be removed if an unusually-shaped workpiece interferes with

handle rotation.

MOUNT THE DRILL PRESS (Fig. H)

The drill press must be securely fastened through the mounting holes

to a stand or workbench with heavy-duty fasteners (Fig. H; fasteners

and mounting hardware not included). This will prevent the drill press

from tipping over, sliding, or walking during operation.

IMPORTANT: If the stand or workbench has a tendency to move

during operation, fasten the workbench securely to the floor.



Fig. E

Fig. F

Fig. G



Fig. H