Use and Care Manual

ASSEMBLY & ADJUSTMENTS



TILT THE TABLE

1. Loosen the bevel lock bolt (Fig. 14 - 1) with a 19 mm socket

or wrench (not included).

2. Tilt the table to the desired angle, using the bevel scale (Fig.

15) as a basic guide.

3. Re-tighten the bevel lock bolt.

4. To return the table to its original horizontal position, loosen

the bevel lock bolt.

5. Realign the table to the 0° setting on the bevel scale.

6. Tighten the bevel lock bolt with the wrench.

Fig. 14

Fig. 15

WARNING: To avoid injury, make sure the chuck

key is removed from the chuck before starting any drill-

ing operation.

INSTALL A DRILL BIT

1. Place the chuck key into the side keyhole of the chuck,

meshing the key with the gear teeth.

2. Turn the chuck key counterclockwise to open the chuck

jaws.

3. Insert a drill bit into the chuck so the chuck jaws grip as

much of the bit's shank as possible.

4. Center the drill bit in the chuck jaws before the final tighten-

ing of the chuck.

5. Tighten the chuck jaws using the chuck key to ensure that

the drill bit will not slip while drilling. Tighten the jaws using all

three keyholes of the chuck.

6. Remove the chuck key. Store in the rubber key holder,

mounted above the feed hub.

Fig. 16