Use and Care Manual



ASSEMBLY & ADJUSTMENTS

INSTALL LASER BATTERIES (PRE-INSTALLED)

1. Turn off the drill laser.

2. Pull the tab located below the laser switch and lift up the laser

switch cover (Fig. 10).

3. Install two AAA batteries into the battery slots and close the

switch cover (Fig. 11).



Fig. 10

Fig. 11

Fig. 12

RAISE OR LOWER THE TABLE

1. Loosen the table locking handle and turn the crank handle

until the table is at the desired height (Fig. 12).

2. Tighten the table locking handle before drilling.

ROTATE THE TABLE

1. Loosen the table locking handle and turn the table around the

column to the desired position.

NOTE: The rack should rotate around the column with the table

support bracket. If the rack binds and does not rotate, slightly

loosen the set screw in the rack collar.

2. Tighten the table locking handle before drilling.

FEED HANDLES

See Fig. 13

1. Insert the three feed handles into the threaded openings on

the feed hub (Fig. 13 - 1).

2. Manually tighten the handles into the openings. If desired,

use an adjustable wrench (not included) to grip the flats of the

feed handles and fully tighten them into the feed hub.

Note: When using the drill press, one or two of the feed han-

dles may be removed if an unusually-shaped workpiece inter-

feres with handle rotation.

Fig. 13