Use and Care Manual



ASSEMBLY & ADJUSTMENTS

ATTACHING COLUMN ASSEMBLY TO BASE

See Fig. 2

1. Place the column tube on the base, aligning the column support

holes to the base holes.

2. Install a hex head bolt in each column support hole and tighten

bolts using the adjustable wrench (not included).

ATTACHING TABLE TO COLUMN

1. Loosen set screw (Fig. 3 - 1) in rack collar and remove the collar

from the column.

2. Remove the rack (Fig. 3 - 3) from the column.

WARNING: Do not plug in or turn on the tool until it is fully assembled according on the instruc-

tions. Failure to follow the safety instructions may result in serious personal injury.

Fig. 2

3. Placing the rack into the table bracket, slide the table assembly with rack down directly onto the column

(Fig. 3). The longer edge of the rack without gear teeth should be towards the top of the drill press.

4. Place the column collar down onto the rack and tigthen the set screw with the smaller hex wrench to

hold the rack in position.

4. Insert the table adjustment handle (Fig. 4 - 1) onto the adjustment shaft (Fig. 4 - 2). Align the socket-

head set screw (Fig. 4 - 3) on the handle with the flat of the adjustment shaft. Using the larger hex wrench,

tighten the set screw.

5. Position the table directly over the base, and tighten the table locking handle (Fig. 5 - 1) to secure table

assembly.



Fig. 3 Fig. 4 Fig. 5

2 3