Use and Care Manual

10
ASSEMBLY & ADJUSTMENTS

1. Head/Motor Assembly (1)
2. Base (1)
3. Table Locking Handle (1)
(with table)
4. Table Assembly (1)
5. Table Adjusting Handle (1)
6. AAA Batteries (2) (inside
head)
7. Chuck (1)
8. Chuck Key (1)
9. Feed Handles (3)
10. Hex Wrench (2)
11. Hex Head Bolts (4)
12. Column Assembly (1)
(with rack and rack collar)
UNPACKING
With the help of a friend or trustworthy foe, carefully remove the drill press from the packaging. Make sure
to take out all contents and accessories. Do not discard the packaging until the drill press is completely
assembled.
The column assembly (column, column support, rack, rack collar, and table support bracket) must be at-
tached to the base. The table and table support handles must be attached to the table support bracket. The
motor housing must be attached to the column.
CLEANING THE WORK TABLE SURFACE
Your drill press comes protected with a layer of anti-rust coating on its exposed (non-painted) metal
surfaces. Clean the rust-protected surfaces using a soft cloth, moistened with kerosene. Do not use gaso-
line, or cellulose-based solvents such as paint thinner or lacquer thinner, as these will damage the painted
surfaces. After cleaning, apply a coat of paste wax to the table and column to prevent rust. Wipe all parts
thoroughly with a clean, dry cloth.
PACKING LIST
Check your packing list against the diagram below. If any part is damaged or missing, please contact
our customer service at [phone], M-F 8-5 CST or email us at [e-mail]
and DO NOT plug the drill press in or turn ON.
Tools needed for assembly (not included):
• Adjustable wrench • Hammer and block of wood, or rubber mallet, or dead-blow hammer