User Manual

DRILL PRESS HEAD TO COLUMN

CAUTION: The drill press head is somewhat heavy. To

avoid injury, it is best if two people place it onto the column.

1. Carefully lift the drill press head assembly and position it over the col-

umn.

2. Place the mounting opening on the drill press head over the top of the

column. Make sure the drill press head is seated properly on the column.

3. Align the direction of the drill press head with the direction of the base

and the table.

4. Tighten the set screws where the head attaches to the column using a

hex wrench.

ASSEMBLY AND ADJUSTMENTS

ATTACHING COLUMN ASSEMBLY TO BASE

1. Place the column tube on the base, aligning the column support holes

to the base holes.

2. Install a hex head bolt in each column support hole and tighten bolts

using the adjustable wrench (Fig A).

ATTACHING TABLE TO COLUMN

1. Slide the table assembly down directly onto the column (Fig. B) with

the top of the table facing upwards.

2. Position the table directly over the base, and tighten the table locking

handle to secure table assembly.

NOTE: Make sure to insert the table locking handle into the side of the

column as shown in Fig. B (the lefthand side if facing the front of the drill

press). Otherwise, the table will not tighten correctly.

Fig. A

Fig. B

Fig. C

FEED HANDLES (Fig. C)

1. Insert the three feed handles into the threaded openings on the feed hub.

2. Manually tighten the handles into the openings.

Note: When using the drill press, one or two of the feed handles may be removed if an unusually-shaped work-

piece interferes with handle rotation.