Product Manual

ASSEMBLING THE WHEELS & STAND (FIG. 1)

1. Insert the wheel axle (A) through the bottom holes of the

stand (B).

2. Slide the wheels (C) onto both ends of the wheel axle.

Secure each wheel with a nut (D).

3. Snap the wheel covers (E) into each wheel.

4. Insert the two ends of the stand assembly into the bot-

tom of the shredder housing (F). Align the holes and secure

with screws (G).

INSTALLING THE PADDLE HOLDER (FIG. 2)

1. Clip the paddle holder (A) onto one side of the stand.

2. Clip the paddle (B) into the paddle holder.

ASSEMBLY & ADJUSTMENTS

1010

WARNING! Do not plug in or turn on the tool until

it is fully assembled according to the instructions. Read

through and become familiarized with the following

procedures of handling and adjusting your tool. Failure

to follow the safety instructions may result in serious

personal injury.

Fig. 1

Fig. 2

Fig. 3

NOTE: Place the paddle back into the paddle holder ev-

ery time after using.

CONNECTING THE EXTENSION CORD (FIG. 3)

1. Make sure the power switch is in the OFF position.

2. Select the correct extension cord according to "Electrical

Information" on page 8.

3. Make a knot with the power cord (B) and the extension

cord (A).

4. Connect the plug and receptacle.

COLLECTING SHREDDED MATERIAL

Your shredder comes with a collection bag. Place the col-

lection bag under the discharge chute to collect shredded

material. See page 9.