Use and Care Manual

OPERATION

Caution: Always wear safety glasses. Wear a filter mask if the operation is dusty. Use of proper gloves and sub-

stantial footwear is recommended when working outdoors.

Caution: Use the blower only in daylight.

STARTING / STOPPING THE BLOWER

To start the blower, squeeze the trigger switch. To

stop, release the switch trigger.

There are two speed buttons on top of the 40V

blower. The bottom button moves the blower into

HIGH SPEED (114 MPH). The top button moves

the blower into TURBO SPEED (124 MPH).

Pressing either button once will engage said speed.

Pressing it a second time will disengage the speed,

bringing the blower back to its original low speed

(92 MPH).

NOTE: Turbo speed has been designed to auto-

shut off after 35 seconds, reverting the blower back

to its low speed.

Turbo

Switch

Trigger

Switch

REMOVING AND CHARGING THE BATTERY

1. Press the lock button on the top center of the battery to slide it out of the blower.

2. Place the battery pack into the charger by sliding it into a locked position until it clicks

3. When the green light is flashing, the battery is charging. If the green light is no longer flashing, the battery is

fully charged.