Use and Care Manual

13
TROUBLESHOOTING GUIDE
PROBLEM CAUSE SOLUTION
Pole saw does not
operate properly
No power supply Check the power supply.
Defective outlet
Try a different source of power. Change as
necessary.
Damaged Extension cable Check cable and replace if necessary.
Defective fuse Replace the fuse.
Pole saw operates ir-
regularly
Damaged power cable Take saw to a service technician.
Loose external connection Take saw to a service technician.
Loose internal connection Take saw to a service technician.
Defective ON/OFF switch Take saw to a service technician.
Dry saw chain
No oil in the tank Refill oil.
Ventilation in the oil tank cap
clogged
Clean oil tank cap.
Oil Tank Flow Clogged Unclog oil flow channel.
Chain/guide rail be-
come too hot
No oil in the tank Refill oil.
Ventilation in the oil tank cap
clogged
Clean oil tank cap.
Oil tank flow channel clogged Unclog oil flow channel.
Dull chain Sharpen or replace chain.
Chainsaw jumps up,
vibrates or does not
saw properly.
Chain tension too loose Adjust chain tension.
Dull chain Rehsarpen or replace chain.
Chain worn out Replace chain.
Saw teeth pulling in the wrong
direction
Remount saw chain with teeth in the cor-
rect direction.