Product Manual

ASSEMBLY & ADJUSTMENTS

UPPER BLADE GUIDES ADJUSTMENT

The upper blade guides need to be readjusted after every blade

change or blade tracking adjustment.

1. Upper Thrust Bearing (Fig. 9 - 1):

Loosen the upper right screw (Fig. 9 - 2) using the S4 hex wrench

to adjust the position of the thrust bearing running along the back

of the blade (Fig. 9 - 1). The bearing should be positioned 0.5 mm

from the back of the blade (Fig. 10). Retighten the screw (Fig. 9 - 2).

2. Upper Side Guides (Fig. 9 - 5):

Loosen the two set screws (Fig. 9 - 4) using the S2 hex wrench to

adjust the two side guides at either side of the blade. The side guides

should be positioned 0.25 mm away from the blade (Fig. 10). Re-

tighten the set screws (Fig. 9 - 4).

Loosen the lower right screw (Fig. 9 - 3) using the S4 hex wrench.

Move the screw to position the side guides 1 to 2 mm from the teeth

of the blade (Fig. 10). Retighten the screw (Fig. 9 - 3).

LOWER BLADE GUIDES ADJUSTMENT

The lower blade guide needs to be readjusted after every blade

change or blade tracking adjustment.

1. Open the lower wheel cover. The table might need to be removed

for easier access to the adjustment screws.

2. The procedure is the same as adjusting the upper guides. Loosen

the lower screw (Fig. 11 - 2) to adjust the thrust bearing 0.5 mm

from the back of the blade. Loosen the upper screw (Fig. 11 - 1) to

adjust the side guides 1 - 2 mm from the teeth of the blade. Loosen

the two set screws (Fig. 11 - 3) to adjust the side guides 0.25 mm

away from the either side of the blade.

3. Close the lower wheel cover.

BLADE GUARD ADJUSTMENT

The height of the upper blade guard (Fig. 12 - 1) should be adjusted

prior to every operation to accommodate the height of the workpiece.

NOTE: The blade guard should be no more than 1/8 of an inch from

the upper edge of the workpiece.

1. Loosen the blade guard locking knob located on the back of the

saw (Fig. 12 - 2).

2. Turn the blade guard adjustment knob (Fig. 12 - 3) to adjust the

height of the blade guard. Lock the upper blade guide locking knob to

secure the guard in place once the desired height has been reached.

0.25 mm0.5 mm 1-2 mm0.25 mm

Side Guides

Thrust

Bearing

Fig. 9

Fig. 10

Fig. 11

Fig. 12