Use and Care Manual

SPECIFIC RULES FOR BAND SAWS
18. Take all necessary precautions to avoid kickback during operation.
19. Plan your cuts so you always cut entirely through the wood. Do not back the workpiece away from the blade
while the saw is running. If you need to remove the blade from a partially cut workpiece, you first must turn the
band saw OFF and wait for the blade to come to a complete stop. Do not twist or put excessive stress on the blade
while removing it from a workpiece.
20. Don’t leave the work area until all moving parts have stopped. Shut off the power to master switches. Remove
the switch key from the band saw and store it in a safe place, away from children. Childproof the workshop!
21. Switch the power to OFF and remove the plug before performing any inspections, adjustments, and mainte-
nance. Wait for all moving parts to come to a complete stop.
22. If any part of this band saw is missing, broken, bent, or damaged in any way, or if any electrical component fails
to perform properly, shut off the power switch, remove the machine plug from the power source and have the dam-
aged, missing, or failed parts replaced before operation.
UNPACKING
Carefully unpack the band saw and all its parts, and compare against the list below. Do not discard the packaging
until the band saw is completely assembled. If any part is damaged or missing, please contact our customer service
at [phone], M-F 8-5 CST or email [e-mail].
Guide Fence
Work Table Assembly (with Hex
Bolt, Lock Washer, Flat Washer
and Wing Nut)
Miter Gauge
S2 Hex Wrench
S4 Hex Wrench
10 mm Wrench
Table Lock Knobs (2)
D6 Flat Washers (2)
7
A.
B.
C.
D.
E.
F.
G.
H.
A
B
C
D
E
F
G
H