Use and Care Manual

ANGLE CUTTING (BEVELING) (Fig. 22)

1. Layout or secure design to work piece.

2. Move the blade guard foot to the highest position by loosen-

ing the height adjustment knob (1). Retighten.

3. Tilt the table to the desired angle by loosening the table bevel

lock handle (2). Move the table to the proper angle using the

degree scale and the pointer (3).

4. Tighten the table bevel lock handle (2).

5. Loosen the blade guard screw, and tilt the blade guard to the

same angle as the table. Retighten the blade guard screw.

6. Position the work piece on the right side of the blade. Lower

the blade guard foot against the surface by loosening the height

adjustment knob. Retighten.

7. Follow steps 5 to 7 under Freehand cutting.

INTERIOR CUTTING (Fig. 23

1. Lay out the design on the work piece. Drill a 1/4” hole in the

work piece.

2. Remove the blade. See Blade removal and installation.

3. Place the work piece on the saw table with the hole in the

work piece over the access hole in the table.

4. Install a blade through the hole in the work piece.

5. Follow steps 3-7, under Freehand cutting.

6. When finished making the interior scroll cuts simply turn

the scroll saw OFF. Unplug the saw before removing the blade

from the blade holder. Remove the work piece from the table.

OPERATION

Fig. 22

Fig. 23