Installation Instructions

Steps
Use the pliers to remove the tip of the black
Loc-line from LED Assembly from your saw.
Cut the LED Lamp off at the end of the Loc-line
assembly.
Remove the two Phillips head screws on the snap flex assembly from the upper arm of the saw.
Pull the Loc-line tube off leaving the wire leads on the saw.
Cut and strip the wire leads about 2 inches from the upper arm.
Cut and strip the wire leads on the replacement
LED Assembly to about 2 inches from the
mounting plate, leaving the rubber grommet in
place on the wire.
Put the cut ends of the red wires into the IDC Connector, then use pliers to squeeze the connector
together. Repeat with the black wires.
Check to make sure the connections are secure.
Push the IDC connectors inside the upper arm.
Secure the newly installed Loc-line LED Assembly with the two Phillips head screws.