Manualshelf

Product Manual

ManualsBrandsWEN ManualsMetalworking ToolsVariable Speed 7 in. x 12 in. 2-Direction Benchtop Metal Lathe
12345678910
9
OPERATION
MOUNTING THE LATHE (FIG. C)
The lathe should be mounted on a strong, heavy
workbench. Take the necessary precautions when
moving the lathe. Assistance may be required.
Bolt the machine firmly to the workbench us-
ing the tapped holes. To do this remove the M6
screws securing the rubber feet in place. Drill four
M6 clearance holes in the worktop and find wash-
ers and M6 screws long enough to securely hold
the unit in place.
HEADSTOCK
The headstock contains the motor, pulleys and the drive belt that turn the spindle used to create your workpiece.
The spindle has a MT3 taper for use in conjunction with a face plate or turning clamp. The spindle has a flange
attached with 6 holes arranged to mount different fixtures, such as chuck jaws and face plates. The speed of the
spindle is adjusted via the Variable Speed Controller on the control panel. The speed ranges can be swapped
between two ranges with the lever on the back of the headstock. Do not change the speed range during operation.
CARRIAGE
The carriage is the portion of the lathe that moves the Cross Slide and Compound Slide across the bed. It can be
manually fed, or driven with the lead screw by engaging the half nuts with the automatic feed lever.
CROSS SLIDE
The cross slide is used to move the tool post and cutting tool across the bed, perpendicular to the lead screw and
the center axis of the spindle. The cross slide is adjusted via a handle with precision tick marks, each indicating
0.001”. This scale will rotate with the handle when it is turned to feed the cross slide back and forth. Before begin-
ning turning, perform the following steps to adjust and zero your cross slide:
1. Turn the handle counterclockwise to back the cross slide 0.015” away from your starting point, then slowly turn
the handle clockwise until the cross slide returns to the starting position. This removes any play in the slide to help
make the scale more accurate.
2. Now hold the handle steady and with your other hand rotate the scale so the “0” lines up with the “0.000” mark
on the cross slide. From this point the slide will remain accurate as long as you only move it forward (toward the
splash guard on the back of the lathe).
3. Any time you back the slide away from your workpiece you will have to repeat steps 1 and 2 before moving the
cross slide forward again for the next cut.
Fig. C
18-3/4 in.
2-7/8 in.