User guide
point secured in the collet, turn on the Cordless Rotary Tool and run the 415
Dressing Stone lightly against the revolving wheel point This removes high spots
and turns up the wheel point to ensure good balance
• To install battery, insert charged battery in the
handle and secure with release button
• To remove battery, press the release buttons,
located below the drill handle and gently pull the
battery pack out
1 Cordless Rotary Tool
2 Battery Pack
3 Release Button
USING THE CORDLESS ROTARY TOOL
• The rst step in learning to use the Cordless Rotary Tool is to get the “feel” of it
Hold it in your hand and feel its weight and balance Feel the taper of the hous-
ing This taper permits the tool to be grasped much like a pen or pencil
• When you turn on the tool for the rst time, hold it away from your face Acces-
sories can be damaged during handing, and can y apart as they come up to
speed This is not common, but it does happen
• Practice on scrap materials rst to see how the Cordless Rotary Tool cuts Keep
in mind that the work is done by the speed of the tool and by the accessory in
the collet You should not lean on or push the tool into the work
• Instead, lower the spinning accessory lightly to the work and allow it to touch
the area you want to cut (or sand or etch, etc) Concentrate on guiding the tool
over the work using very little pressure from your hand Allow the accessory to
do the work
• Usually, it is best to make a series of passes with the tool rather than attempt to
do all the work in one pass To make a cut, for example, pass the tool back and
forth over the work
• Cut a little material on each pass until you reach the desired depth For most
work, the deft, gentle touch is best With it, you have the best control, are less
likely to make errors, and will get the most efcient work out of the accessory