Use and Care Manual

OPERATION

ADJUSTING THE BEVEL ANGLE

The base plate may be tilted to allow angle cuts up to 45 degrees in

either direction.

1. Unlock the angle adjustment lever (Fig. 6 - 1) located on the back

of the saw under the battery.

2. Adjust the base plate to the desired angle and relock the angle

adjustment lever.

SAWING OPERATION

NOTE: For the best performance, always select a speciﬁed blade for

the particular application and type of material you wish to cut.

A. GENERAL CUTS

1. Place the front of the saw base on the workpiece.

2. Align the cutting edge of the blade with the line of your workpiece.

3. Start the saw and move it forward on the workpiece along the line

of cut.

B. PLUNGE CUTS (Fig. 7)

1. Mark the line of cut clearly on the workpiece.

2. Set the bevel angle to 0 degrees.

3. Place the front of the saw base on the workpiece.

4. Press the power trigger in for high speed and slowly lower the

blade into the workpiece until the blade cuts through the wood.

Fig. 6

WARNING! To decrease the risk of injury, keep your hands

away from the blade and all moving parts. Always wear safety

glasses.

Fig. 7