Use and Care Manual

OPERATION

SETTING THE BLADE ORBIT

Use the blade orbit selector dial (Fig. 5 - 1) to set the correct blade

orbit for your operation. Refer to the chart below for setting the blade

orbit:

Fig. 5

Setting 0 - Hard materials such as metals or thin sheet

metals. This setting can be used with knife blades, grit

edge blades, rasp work, and down cutting blades. This

setting can also be used for round cuts.

Setting 1 - Soft materials where cleaner cutting or

delicate scrolling work is performed.

Setting 2 - Medium density materials such as harder

woods or particle board.

Setting 3 - Soft materials such as wood, plastic, etc.

This setting can be used when fast cutting is more

important than a clean cut.