Use and Care Manual

OPERATION

STARTING THE JIG SAW

1. To start the jig saw, press the power trigger (Fig. 3 - 1).

2. For continuous power, press the power lock-on switch (Fig. 3 - 2)

while also pressing the power trigger. This will lock the power trigger

in the ON position.

3. To stop continuous power, press the power trigger again. The pow-

er lock-on switch will disengage and power will stop.

4. Pull the power trigger to start the saw. The LED light on the front

of the saw will illuminate.

5. To increase the speed of the saw, rotate the speed dial (Fig. 4 -

1). Your saw can operate at speeds between 0 and 3100 SPM. The

optimal cutting speed depends on the material being cut, the type of

blade being used, the thickness of the workpiece, and the feed rate

preferred by the operator. As a general rule, use slower speeds for

denser materials or harder materials, and faster speeds for softer

materials. To best determine the cutting speed, test on a scrap piece

of identical material and adjust accordingly.

STOPPING THE JIGSAW

1. Release the power trigger. The LED light on the front of the saw

will turn off.

2. Remove the battery when storing the tool to avoid accidental start

ups.

Fig. 3

Fig. 4