Use and Care Manual

WARNING! To avoid injury from accidental startups, make sure that the tool is OFF and the battery is re-
moved from the jig saw.
ASSEMBLY & ADJUSTMENTS
13
INSTALLING AND REMOVING THE BLADE
1. Rotate the blade clamp lock (Fig. 1 - 1) counterclockwise to loosen
the blade. Hold the lock in the open position.
2. Insert the new blade with teeth facing forward between the blade
clamp (Fig. 1 - 2) and the front wire guide.
3. Close the blade clamp lock. Make sure that the blade is fully seated
in the clamp lock before beginning operation.
Fig. 1
1
WARNING! Always use sharp blades for the best results. DO
NOT use blades that are bent, deformed, or damaged.
INSTALLING THE STRAIGHT GUIDE
1. Loosen the two straight guide lock knobs (Fig. 2 - 1).
2. Place the straight guide (Fig. 2 - 2) through the two slots below
the lock knob.
3. Adjust the straight guide to your desired width and secure in place
by retightening the lock knobs.
Fig. 2
1
2
2