Product Manual

11
KNOW YOUR IMPACT WRENCH
1/4-Inch Drive Chuck
TOOL PURPOSE
Easily drive long deck screws or carriage bolts with your WEN Impact Driver. Refer to the following diagrams to
become familiarized with all the parts and controls of your impact driver. The components will be referred to later in
the manual for assembly and operation instructions.
Direction of Rotation Switch /
Power Trigger Lock
LED Work Light
Power Trigger
Handle Grip
Battery Pack Release
Belt Clip
2.0 Ah Battery Pack
OPERATION
CHARGING THE BATTERY PACK
The 20V battery pack for this tool is supplied in a low charge condition to prevent possible problems, and must be
charged completely before you use the tool for the first time.
1. Connect charger to a 120V, 60Hz AC outlet. Green light on charger will illuminate, indicating charger is powered.
2. Slide the battery all the way into the charger until it clicks. The red light on the charger will illuminate, indicating
that the battery is charging.
Charging Indication:
• Solid Green: Ready to Charge
• Solid Red: Charging
• Solid Green: Charged
3. When the battery is charged, the red light will turn off and the green light will turn on. Remove the battery from
the charger and unplug the charger from the power supply.
NOTE: Battery will not reach full charge the first time it is charged. Allow several cycles for the battery to fully
charge. The battery pack may become warm while charging; this is normal. If the battery is hot after continuous use
in the tool, allow it to cool to room temperature before charging. This will prolong the life of your battery.