Owner`s manual

of oil from the following chart that matches the starting temperature anticipated before
the next oil changes.
Figure 1- Engine oil recommendations
To fill oil to the crankcase, follow these steps:
1. Make sure the generator is on a level surface. Tilting the generator to assist in filling will
cause oil to flow into engine areas and will cause damage. Keep generator level!
2. Remove the oil filler/dipstick cap from the engine as shown in figure 2.
3. Using a funnel, add the appropriate type and amount of oil into the crankcase. The
crankcase is full when the oil level has reached the second thread from the lip of the
opening (see figure 3).
4. Check for oil leaks. Reinstall oil filler cap before starting engine.
Figure 2- Unscrewing the oil cap Figure 3- filling oil
Step 2- Add Gasoline
WARNING: This generator may emit highly
flammable and explosive gasoline vapors, which can
cause severe burns or even death if ignited. A nearby
open flame can lead to explosion even if not directly in contact with gasoline.
• Do not operate near open flame.
• Do not smoke near generator.
• Always operate on a firm, level surface.
• Always turn generator off before refueling. Allow generator to cool for at least 2
minutes before removing fuel cap. Loosen cap slowly to relieve pressure in tank.
• Do not overfill fuel tank. Gasoline may expand during operation. Do not fill to the
top of the tank. Allow for expansion.
• Always check for spilled fuel before operating. Clean up any spilled fuel before
starting.
• Empty fuel tank before storing or transporting the generator.
• Before transporting, turn fuel valve to off position and disconnect spark plug wire.
10