Owner`s manual

11
At this point, gently remove the two wheels from underneath the generator.
a b
Figure 3- handle assembly
Attach Wheels
To attach the wheels to the generator, perform the following steps:
1. Find a wood block or similar item that is 3 inches thick or greater and rest the exhaust end of the
generator on the block as shown in figure 4.
2. Take one wheel shaft, one spacer, and one M12 nut as shown. Place the spacer between the two
holes on the frame bracket. Slide the wheel shaft, with the threaded part facing inward, through the
frame and spacer. Secure using an M12 nut and the included wrench as shown in figure 5.
3. Slide the wheel onto the axle and secure in place using a large cotter pin as shown in figure 6.
Spread the pin legs apart slightly to help secure the pin in place.
4. Repeat steps 2 and 3 for the other wheel.
At this point, the generator assembly is complete. Gently remove the generator from the wood block.
Figure 4- supporting the generator Figure 5- axle assembly
a Figure 6- wheel installation b
a b