Setup Guide

Connect Wemo Dimmer wires
5
After detaching and removing the existing switch, snap
the cover plate o of your Wemo Dimmer, and remove
the sticker securing the wires.
Remove cover plate
Connect LINE and LOAD wires
NOTE: Your existing wires may be dierent colors than
those shown.
Use a wire nut to connect the red LOAD wire on the
Dimmer to the LOAD wire in the wall.
Use a wire nut to connect the black LINE wire on the
Dimmer to the LINE wire in the wall.
LINE
LOAD
Make sure the power is OFF before
proceeding.
!