User Manual
Table Contents Table of Contents Important safety instructions ...................................................01 1. Know your air purifier ..........................................................03 2. Get started 2.1 Install the filter ..............................................................04 3. Use an air purifier 3.1 Know the control panel...................................................06 3.2 Know the filter replacement indicator ..............................06 3.3 Regulating fan speed .....
01
02
1.Know your air purifier Thank you for choosing the air purifier produced by our company. Before using, please read this manual in detail to correctly grasp the use of this air purifier in order to give full play to the best performance of the purifier. 1. Air outlet cover 2. Control panel 3. Viewing window 4. Main unit 5. Decorative board 6.
Get started 2.Get started Install the filter: A high-efficiency composite filter is included inside the air purifier. Before using the product, the packing of the filter must be removed. Remove filter assembly and its packing as follows, then put it back in the air purifier. Holding tabs Main unit Filter Pre-Filter Back cover Note: Install the filter in the correct position. Make sure that the side with holding tabs is facing outward.
1.Hold the machine and the top left and right sides of the back cover with both hands, and press the back cover with your thumb.(When you hear a “clicking” sound) The back cover pops open. 2. Grab the back cover and remove the main unit. Then pull the packaged filter outward to remove it from the machine and remove the plastic bag from the filter. 3.
3.Use an air purifier 3.1Know the control panel: Timer button Filter replacement tips Temperture display Humidity display °F Regulating fan speed AUTO AUTO %rh UV WIFI UV lamp Timing remaining (or PM2.5 unit quantity) Sleep Switch 3.2 Know the filter replacement indicator: An effective composite filter assembly is included inside the product. When the indicator light is on, it indicates the filter needs to be cleaned or replaced. 3.
Use an air purifier 3.5 Timer button 1. Touch the timer button once to enter the query for the remaining time. “888” displays the remaining time. If there is no operation within 5 seconds, and it will automatically return to display PM2.5. 2. In the state of query, touch the timer button once again , flashes, and then “888” and the clock light on the left of it are on. 3. Enter the timing state. Touch the timer button once, the timing mode of “1H-2H- 4H-8H-...” is displayed on the LED screen. 4.
4.Filter relacement When the filter replacement indicator you need to check to replace the filter. is flashing, it reminds you that Note: High-efficient composite filters can not be washed in water or cleaned by vacuum cleaners. Make sure the side with the holding tabs is facing outwards. 1. Turn off the purifier and unplug the power cord. As shown in Figure (a). 2. Hold the machine and the top left and right sides of the back cover with both hands, and press the back cover with your thumb.
5. Put the filter back into the air purifier. See Figure (e) Note: 6. Put the filter back into the rear of the purifier, then fit the three flat columns at the bottom of the back cover to the three holes at the bottom of the rear of the purifier. Hold the top left and right corners of the back cover with both hands and push the back cover into the rear of the purifier. (When you hear “clicking” sound) The back cover is locked. As shown in Figure (f).
5.Clean the pre-filter A vacuum cleaner can be used to regularly clean dirt on the pre-filter, or it can be washed and dried for further use. 6.Know LED display on the viewing window There is an LED backlight on the viewing window (three colors of red, blue and green respectively), and the color of the light is automatically displayed according to the number of PM2.
Troubleshooting 7.Failure modes and treatment methods This chapter summarizes the problems you most often encounter when using an air purifier. If you are unable to solve the problem based on the information below, please contact the Customer Service Center in your country.
8.
9.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
