User's Manual
ݼߧ֣ю҈Հৰ
خ
خ
'܉ߐࡌ
ߕމMՅୢ
ܑٗவԥԭӳ௲
(Ӳҁࡌ
֣О ؾتબЕࠀܷࣁ֣ؾت֣ࠄѹԭӳ!
ґચӄؠࢎޱљՃҿ࠳ۅ؏ޅۅઁࠀӕͺ
ОହҲଞૄબ֨ଟ߽ߡ۪ଟםૄӹબґڙٴ䓓Љڱӟ࣫
வ䥉婰澝ࢥԭ澝Ռڧ澝ٛঈЉەӑ澞
ߕމڷீଋ8U.9࣪ґઍચ澞
Ӥি
Թি
߶ࡨ
يڐؾتSS
ۨսؾتSS
ؾت Ҹٛқ rSS
࣒މ
)4מࡐ圎ߑ=O,O࣍
પޢаܑ
>>>>>>>
դ
ޙߊ
'
࣍ߎ
Պӄؠ
ٺБ֘߄ஒҸ՛
-;'4-*54-1+-'5+2+):854/)9)52:*
Ӳ֣
ؙ߾
܅ӕ
*GZK
*GZK
*GZK
PPPP
PP PP PP PP PP
Aroma Diffuser
D300
User Manual
Product Specification
Operation Approach Troubleshooting
Product Feature
DC Plug
AC
Adaptor
Clean Brush
Air inlet
DC
Socket
Splash Guard
Air Outlet
Base
Max Water Level
Ceramic
Disc
Timer
Indicator
Lights
Mist
Level
Button
ON
Indicator
Light
Timer
Button
Light
Button
Mist Tube
Cover
Add water
from the top
Function Characteristics
0LVW/HYHO
1.
2.
3.
Long press and the diffuser will start on the low mist level, the ON light will
turn on and the buzzer will sound for 1 second.
Then short press to use the high mist level. Buzzer will sound twice.
Long press again to turn misting off. The ON light will turn off and the buzzer
will sound for 1 second.
7LPHU
1.
2.
3.
Press to adjust timer lengths (1, 3, 6 hours) and to turn the timer off.
The diffuser will turn off at the end of the timer.
The timer will only be used when mist is turned on.
5*%/LJKW
1.
2.
3.
4.
Press and the RGB light will start on the gradient mode.
Then press to choose a colour between 7 colors.
Continue to press briefly to return to gradient mode and cycle control.
Long press to turn the RGB light off.
0HPRU\)XQFWLRQ
1. When the diffuser turn off, it will remember your mist and light settings when
turned back on.
:DWHUVKRUWDJHSURWHFWLRQ
1. With water shortage detector, when being in operation, it will automaticlly power
off if waterless, which can protect the atomizer from being burnt and broken.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the follow-
ing measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, this equipment
should be installed and operated with minimum 20cm distance between the
radiator and your body: Use only the supplied antenna.
Please open the top cover. Add around 300mL tap water
inside the water tank.
Avoid essencial oil or acetone
chemicals dropping on the cover
surface, in case of the painting peeling
off.
Please do not exceed the max water
line when filling water inside, two or
three drops of essential oil is enough
for 300mLwater.
Close the top cover.
Insert the adaptor plug into
household power socket.
Essential oil
Water
Problems Possible Reasons Handling
Unable to
spray mist or
spray bad.
Main body is
leaking water.
Low temperature and wet humidity may
cause machine sweats.
If the room temperature is low or
with wet humidity?
If the top cover is rightly covered?
If top cover is not rightly covered, the water
will splash out and fall onto machine body
or table.
Please clean away the dust of bottomair inlet.
Please replace the top cover.
Please clean the water trough.
If the water volume exceeds 300mL(max water
line), the mist volume will be very small.
Power not connected.
Power wire broken or adaptor
burn out.
If the bottom air inlet is dirty?
Is top cover rightly placed?
Is the ceramic disc dirty?
If the water inside tank is
too much?
If the water inside tank is nat
enough?
Please fill the water.
Please contact local retailer.
Connect the power, press power button.
No electricity,
not working.
If start up the machine but it doesn't work, please check
the followings.
$%HWWHU/LIH,V:RUWK/LYLQJ