Specifications

SERVICING INSTRUCTIONS (continued)

SERVICE

POWER SWITCH

Repair time not to exceed 0.5 hour

A. Preparation

1. Disconnect Water-Max™ from electrical power.

2. Shut off water supply to Water-Max™.

B. Removal

1. Remove front assembly and tank shelf (see page 27).

2. Remove paper shield.

3. Note position of wires on switch. Disconnect wires.

4. Compress mounting fingers on switch. Push switch from inside

to remove; discard old switch.

C. Installation

1. Note orientation of switch. ON ( I ) goes up.

2. Push switch through mounting hole until fingers engage

and the flange of the switch sits flush against the cabinet.

3. Reinstall wires.

4. Reinstall paper shield, front assembly and tank shelf.

D. Return Unit to Service

1. Turn water supply on and check for leaks.

2. Connect Water-Max™ to electrical power and test for

proper operation.

WARNING

Electric Shock

Hazard

Disconnect Water-Max™ from

electrical power before removing

any panel or cover.

TOOLS REQUIRED:

#2 Phillips Screwdriver

Container to hold fasteners

Needle Nose Pliers