Service manual

PAGE 3-2 SERVICE MANUAL WG-xxG Series Gas Griddle Installation
SETTING ZONE THERMOSTATS
Each heated zone of the cooking surface has a snap
action thermostat to control the gas valve for that
section. Access to set each control knob is by lowering
the front panel.
Each thermostat is fitted with a control knob dial
scaled, "OFF"-200" to 450° F.
Each thermostat mounting bracket has a "V" notch at
the top as a pointer index for setting the control dial
knob.
After the pilots have been lighted and proven
established, turn rotate the knob to the desired (200*
to 450° F.) temperature.
After the surface has heated and the thermostats have
cycled several times, the surface temperature should
be within ± 25°F. of the dial setting. Variations of less
than ± 25° are normal and can be compensated for by
simply adjusting the knob to get the desired
temperature.
REVIEW OPERATION OF GRIDDLE
After all operational tests have been completed it is
advisable to show the end user each control and their
functions in operation of the griddle.
A review of the operating instructions with the end user
will reduce unnecessary calls for assistance at a later
date.
8