Specifications

TROUBLE SHOOTING SUGGESTIONS
9
004 p/n 305145 OpM LL-Series Warmers
SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY
No power to warmer
Circuit breaker off or tripped Reset circuit breaker
Unit not plugged in
Make sure unit is plugged in to
power receptacle
Warmer will not heat
Temperature control not set
Set control to desired
temperature
Internal damage
Contact you Authorized Wells
Service Agency for repairs
Warmer trips circuit breaker
Wet insulation Allow to dry or replace insulation
Pan leaking or other internal
damage
Contact your Authorized Wells
Service Agency for repairs
Internal damage
Contact your Authorized Wells
Service Agency for repairs
Mineral deposits on pan acting
as a insulator
Clean pan(s) with delime
cleaner. DO NOT USE ON
ALUMINUM SURFACES!
Connected to wrong voltage
Verify supply voltage (must
match voltage on warmer
nameplate)
Too much water in pan
Remove water from pan until 1”
of water remains in pan
Warmer slow to heat
There are no user-serviceable components in this appliance.
In all instances of damage or malfunction, contact your Authorized Wells Service Agency for repairs.