Operating instructions

WARMERS WITH MANIFOLDED DRAIN

1. Manifolded warmers have a single drain valve.

2. Water poured into any one section will seek the same water

level with all sections on the manifold.

3. Make sure the drain valve is fully closed before filling warmer.

AUTOFILL WARMERS

1. Autofill warmers sense water level by a sensor placed at the

proper level. For manifolded autofill warmers, the water level

sensor / fill tube is in one pan only, normally in the far left pan.

2. Water fills the pan through an inlet tube. For manifolded

autofill warmers, the fill tube is normally in the far left pan. All

other sections fill at the same time through the drain manifold.

3. The autofill function is active only when the thermostat for the

pan with the water level sensor is turned ON .

4. Make sure the drain valve is fully closed before turning any

thermostats ON.

5. The autofill function is only activated when the far left

thermostat is turned ON. For manifolded autofill warmers, be

sure to turn far left thermostats ON before turning any other

control ON, to avoid heating a dry pan.

6. DO NOT use autofill warmers in the dry mode. This may

damage the water level sensor probe. NEVER turn the

thermostat ON for the pan with the probe and fill tube unless

the entire warmer unit is to be used in the wet mode.

7. Clean water level sensor daily to maintain water level in

warmer.

DO NOT use autofill

warmers in the dry mode.

This may damage the water

level sensor. NEVER turn the

thermostat ON for the pan

with the sensor and fill tube

unless the entire warmer unit

is to be used in the wet

mode.

OPERATION

011 303308 OpManual for Built-In T’Stat Warmers