Operating instructions

DAILY CLEANING INSTRUCTIONS

PREPARATIONS: Turn control knob(s) to OFF. Allow warmer to cool

before proceeding.

Remove any insets, pans and/or adapter tops.

Drain or remove water from well if used for

wet operation.

FREQUENCY: Minimum - daily.

TOOLS: Mild Detergent

Solution: 10 Parts Warm Water to 4 Parts Vinegar

Plastic Scouring Pad

Clean Cloth or Sponge

Food-Grade Silicone Sealant

1. Wipe entire unit down using a clean cloth or sponge and mild

detergent. Carefully wipe any debris and residue from the water

level sensor (auto-fill units).

2. Use a plastic scouring pad to remove any hardened food particles

or mineral deposits. IMPORTANT: Do NOT use steel wool for

cleaning.

3. Rinse warmer thoroughly with a vinegar and water solution to

neutralize all detergent cleanser residue.

4. Inspect warmer flange-to-counter seal. Reseal with food-grade

silicone sealant if necessary. Failure to do so may allow grease and

water to leak into insulation and heating element, causing a potential

fire and/or electric shock hazard.

5. Inspect warmer tank for damage. Damage to the outer body may

allow grease and water to leak into insulation and heating element,

causing a potential fire and/or electric shock hazard. Contact your

Authorized Wells Service Agency to inspect warmer if water or

grease contamination is suspected.

6. Close drain valve. Add proper amount of warm water. Turn control

knob(s) ON and check for proper operation.

CLEANING INSTRUCTIONS

011 303308 OpManual for Built-In T’Stat Warmers

CAUTION:

SHOCK HAZARD

Do NOT splash or pour water

into or over any control panel

or wiring.

CAUTION:

SHOCK HAZARD

Disconnect warmer from

electric power before cleaning

CAUTION:

BURN HAZARD

Allow warmer to cool

completely before cleaning.