Installation manual

Northern Health
Lakes District Hospital and Health Care Centre
Burns Lake, B.C
Section 11 40 03
FOODSERVICE - EQUIPMENT
ITEMIZED SPECIFCATIONS
Page 11 of 18
secured as required
ITEM 30
FLOOR DRAIN PAN 1 REQUIRED
Manufacturer: Custom Fabricated
Size: Refer to plan and site; 450 x 750 x 150mm deep
Construction: 16 gauge stainless steel construction as specified
Shallow depth units to suit site conditions
All welded, refer to detail on Building Conditions drawing
Stainless steel tail piece and waste, confirm location with site
Slope to drain
Pan to be flush with finished floor and, where required, to have "Z" bars
welded to bottom for support
75mm (3”) diameter stainless steel pipe, caulked into trap – threaded or
smooth to be verified with AHJ
Components: Grating to be fibergrate molded fiberglass, honeycomb or similar removable
grate approved for foodservice areas or slot grating with slots no greater
that 19mm (¾”) width space
Grating is to be supplied with grit skid-resistant walking surface
All cut or sanded surfaces are to be sealed with resin prior to installation
Grating to sit on trough ledges and, where required, on stainless steel
angles - to be removable in sections no greater than 450 x 1220mm (18” x
48”)
Grating to be level with finished floor
Pipe welded onto Component Hardware D43-X015 drain complete with lift
out strainer basket D34-X016 or equivalent – verify code requirement for
threaded pipe, provide threaded pipe if required by code
ITEM 31
MOBILE WORK TABLE 1 REQUIRED
Manufacturer: Custom Fabricated
Size: Refer to plan and elevation; 750mm deep; refer to Standard Detail D-7.2
Construction: Stainless steel construction as specified
Boxed edges
Solid bottom shelf, mounted 10”/250mm AFF, with boxed edges
Components: 1 required drawer, as specified, with removable plastic liner, 6”/150mm
deep
127 mm diameter heavy duty casters, 4 with brakes corner casters with
donut bumpers, 4 swivel, 2 fixed one end
ITEM 32
spare
ITEM 33
REACH-IN REFRIGERATOR - Existing 1 EXISTING
Manufacturer: Obtain unit from owner; replace door gasket; inspect refrigeration system -
notify in writing if system requires service; clean and relocate as shown
ITEM 34
WORK COUNTER 1 REQUIRED
Manufacturer: Custom Fabricated
Size: Refer to plan and elevation; 760mm deep; refer to Standard Details D-7.1,
D-7.3
Construction: Stainless steel construction as specified
Boxed edges