Specifications

ADJUSTMENT OF THE DOOR (TOP TO
BOTTOM)
Tools: Phillips Head Screwdriver, 10" (25 cm) .
adjustable wrench.
Parts: None.
1. Unplug the power cord.
WARNING: Failure to do so will result in
electrical shock.
2. Remove the lower front trim by removing the 4
screws located on the sides of the trim piece.
3. TO RAISE THE DOOR -
A. Using the 10" (25 cm) adjustable wrench, loosen
the retaining nut located at the bottom of the brass
hinge sleeve. (See Figure 22)
B. Using the 10" (25 cm) adjustable wrench, turn the
brass hinge sleeve COUNTERCLOCKWISE to raise
the door. (See Figure 22)
C. After the proper adjustment has been made,
tighten the retaining nut up to the bottom of the
brass hinge sleeve.
4. TO LOWER THE DOOR -
A. Using the 10" (25 cm) adjustable wrench, loosen
the retaining nut located at the bottom of the brass
hinge sleeve. (See Figure 22)
B. Using the 10"" (25 cm) adjustable wrench, turn
the brass hinge sleeve CLOCKWISE to tower the
door. (See Figure 22)
C. After the proper adjustment has been made,
tighten the retaining nut up to the bottom of the
brass hinge sleeve.
5. Once the proper adjustment has been made
replace the lower front trim.
ADJUSTMENT OF THE DOOR TO THE DOOR
GASKET
Tools: Phillips Head Screwdriver, 7/16" (11 mm)
Ratchet/Socket Assembly (with minimum 2
1/2" (6,4 cm) extension)
Parts: None.
1. Unplug the power cord.
WARNING: Failure to do so will result in
electrical shock.
2. Remove the lower front trim by removing the 4
screws located on the side of the trim piece.
3. Remove the top from the oven by removing the
8 screws located around its perimeter (note:
the prep-top must be removed if it has been
installed).
4. For each of the hinge brackets, top and bottom,
adjust as follows:
DOOR CLOSER TO THE GASKET -
Turn the center bolt CLOCKWISE to the gasket,
then tighten the 2 outer bolts to secure it in place.
(See Figures 23 & 24)
29