011A WELLS BLOOMFIELD, LLC 10 Sunnen Dr., St. Louis, MO 63143 telephone: 314-678-6314 fax: 314-781-2714 www.wellsbloomfield.
LIMITED WARRANTY STATEMENT Unless otherwise specified, all commercial cooking equipment manufactured by WELLS BLOOMFIELD, LLC is warranted against defects in materials and workmanship for a period of one year from the date of original installation or 18 months from the date of shipment from our factory, whichever comes first, and is for the benefit of the original purchaser only. The prices charged by Wells Bloomfield for its products are based upon the limitations in this warranty.
TABLE OF CONTENTS WARRANTY FEATURES & OPERATING CONTROLS PRECAUTIONS & GENERAL INFORMATION AGENCY LISTING INFORMATION INSTALLATION OPERATION MAINTENANCE INSTRUCTIONS CLEANING INSTRUCTIONS TROUBLESHOOTING SUGGESTIONS EXPLODED VIEW & PARTS LIST WIRING DIAGRAM PARTS & SERVICE CUSTOMER SERVICE DATA xi 2 3 3 4 6 7 8 10 11 14 17 17 INTRODUCTION Thank You for purchasing this Wells Bloomfield appliance.
FEATURES & OPERATING CONTROLS A. THERMOSTAT 1. On THERMOSTATICALLY CONTROLLED warmers, power is applied to the heating element according to the control knob position and the actual temperature at the temperature sensing thermobulb. INDICATOR LIGHT 2. The desired temperature is controlled by rotating the TEMPERATURE CONTROL KNOB. The knob has a numeric scale, where higher numbers correspond to higher temperature. TEMPERATURE CONTROL KNOB 3.
PRECAUTIONS AND GENERAL INFORMATION This appliance is intended for use in commercial establishments only. WARNING: WA This appliance is intended to hold pre-heated food for human consumption. No other use is recommended or authorized by the manufacturer or its agents. SHOCK HAZARD SHO Operators of this appliance must be familiar with the appliance use, limitations and associated restrictions. Operating instructions must be read and understood by all persons using or installing this appliance.
INSTALLATION WARNING: WA RISK OF INJURY RIS Installation procedures must be performed by a qualified technician with full knowledge of all applicable electrical and plumbing codes. Failure can result in personal injury and property damage. CAUTION CA FIRE HAZARD Av Avoid storing flammable or combustible materials in, on or near the appliance.
INSTALLATION 4. a. b. c. Top-Mounted Warmers Verify that provided sealants are applied to the underside of the warmer top flange prior to setting the unit into the cutout. After installation, verify that all supplied fasteners and other mounting hardware is properly installed and tightened. Apply a thin bead of food-grade silicone sealant around the flange to seal it to the counter. ELECTRICAL INSTALLATION 1. Refer to the product nameplate. Verify the electrical service power.
OPERATION HOT SURFACE Exposed surfaces can be hot to the touch and may cause burns. CAUTION: SHOCK HAZARD DO NOT splash or pour water onto control panel or wiring. WET OR DRY OPERATION for WARMERS 1. Carefully read the description of the warmer operation on the specification sheet. 2. a. Most warmers are designed for WET OR DRY operation. b. Warmers may be used wet, or may be used dry.
MAINTENANCE INSTRUCTIONS CARE OF STAINLESS STEEL Stainless steel is a marvelous material: strong, lustrous and low maintenance. With a minimum of care, it will normally retain its beauty and durability for the life of the equipment. In some applications, however, special care is required in order to maintain stainless steel’s special properties. External components, such as cabinets and control panels, are finished with a grain pattern.
CLEANING INSTRUCTIONS CAUTION: CA SHO SHOCK HAZARD Do NOT spl splash or pour water into or over any control panel or wiring. CAUTION: CA DAILY CLEANING INSTRUCTIONS PREPARATIONS: Turn control knob(s) to OFF. Allow warmer to cool before proceeding. Remove any insets, pans and/or adapter tops. Drain or remove water from well if used for wet operation. FREQUENCY: Minimum - daily.
CLEANING INSTRUCTIONS WEEKLY CLEANING INSTRUCTIONS CAUTION: CA PREPARATIONS: CH CHEMICAL BURN HAZARD HA Remove any insets, pans and/or adapter tops. Drain or remove water from well if used for wet operation. FREQUENCY: Weekly, or whenever lime or scale is seen accumulating on the sides of the warmer pans. TOOLS: Commercial Delime Cleaner Plastic Scouring Pad Clean Cloth or Sponge 1. Add water to pans until water is at normal operating level (1” - 1 1/2” deep) or covers accumulated scale. 2.
TROUBLESHOOTING SUGGESTIONS SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY No power to warmer Circuit breaker off or tripped Reset circuit breaker Warmer will not heat Temperature control not set Set control to desired temperature Wet insulation Verify flange-to counter seal is sound, or reseal with food-grade silicone sealant Pan leaking or other internal damage Contact your Authorized Wells Service Agency for repairs Internal damage Contact your Authorized Wells Service Agency for repairs Mineral d
EXPLODED VIEW & PARTS LIST MODEL HMP-6 PAN ASSEMBLY P2-305802 ELEMENT PAN WS-505643 ELEMENT CLIP 2C-30397 STRAIGHT CONDUIT FITTING 2K-37748X PILOT LIGHT RETAINER CLIP 2C-63271 K-TYPETHERMOSTAT CONTROL 2T-38968 RED LIGHT SIGNAL 2J-35687 POP RIVET 2C-34284 THERMOBULB BRACKET D8-303352 HI M011A.
EXPLODED VIEW & PARTS LIST MODEL HMP-6D DRAIN SCREEN ASSEMBLY P2-31869 PAN ASSEMBLY P2-41463 PILOT LIGHT RETAINER CLIP 2C-43271 K-TYPE THERMOSTAT 2T-38968 WE LL S POP RIVET 2C-34284 CONTROL KNOB ASSEMBLY 2R-40498 HEATING ELEMENT 2N-45431UL ELEMENT CLIP 2C-30397 THERMOSTAT PLATE P2-41461 STRAIGHT CONDUIT FITTING 2K-37748X ELEMENT COVER P2-41462 MODEL:HMP-6D IL2006a 12 M011A.
EXPLODED VIEW & PARTS LIST MODEL HMP-6ULD Wireset for HMP6DU6 use P2-41317A DRAIN SCREEN ASSEMBLY P2-31869 PAN ASSEMBLY P2-41463 K-TYPETHERMOSTAT 2T-38968 (6’ use 2T-46551) CONTROL BOX P2-306959 PLATE,THERMO P2-45614 M011A.
WIRING DIAGRAM HMP-6 Series 14 M011A.
M011A.
NOTES 16 M011A.
PARTS & SERVICE DESCRIPTION PART NO. ACCESSORIES IMPORTANT: Use only factory authorized service parts and replacement filters.
WELLS BLOOMFIELD, LLC 10 Sunnen Dr., St. Louis, MO 63143 telephone: 314-678-6314 fax: 314-781-2714 www.wellsbloomfield.
