Specifications

INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on
the inside front cover of this
manual.
DANGER:
HEALTH
HAZARD
This appliance must be
properly ventilated. Failure to
provide and maintain proper
ventilation of exhaust gasses
can result in severe injury or
death.
WARNING:
FIRE HAZARD
Do not store gasoline or
any other ammable or
combustible material near this
appliance. The open ame
can cause such materials to
ignite.
The area where the griddle is
installed must be kept clear of
combustibles and ammables.
This includes mops, rags,
grease, wrapping paper and
electric cords.
NOTICE: Manufacturer’s
warranty on this griddle is in
effect only when the griddle is
installed in accordance with
these instructions and local
codes and ordinances or, in
the absence of local codes,
the National Fuel Gas Code,
ANSI Z223.1 (current edition).
The manufacturer of this
griddle assumes no liability for
any damage or injury resulting
from failure to comply with this
notice.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective
plastic lm, packing materials and accessories from the appliance
before connecting performing any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before discarding
packing materials. Store all accessories in a convenient place for later
use.
COMPONENTS
Dual Burner (-2430G, 2 ea.; -3630G, 3 ea.; -4830H, 4 ea.)
Adjustable Legs (set of 4)
Grease Tray (-2430G, 1 ea.; -3630G, 1 ea.; -4830H, 2 ea.)
SETUP
Setup the griddle only on a rm, level, non-combustible surface.
Verify local codes for requirements. Concrete, tile, terrazzo or metal
surfaces are recommended. Metal or tile over combustible material
may not meet code for non-combustible surfaces.
Install the provided adjustable
legs, one on each corner of the
appliance, in the holes provided.
Verify that the unit sits rmly
on ALL FOUR legs. With the
adjustable legs, adjust as required
to level the appliance. All four legs
must be adjusted to rmly contact
the countertop in order to prevent
tipping.
Adequate clearance for air
openings in the cabinet must be
provided. Refer to the Installation
Instruction Sheet for required clearances. Maintain required clearances
between the appliance and adjacent combustible surfaces.
The griddle must be installed in an area with sufcient make-up air
for proper combustion, and must be installed such that the ow of
combustion and ventilation air will not be obstructed.
When used with an exhaust fan, special precautions must be observed
to avoid interference with the operation of the griddle, such as drafts
and air starvation.
4
M122 2M-306626 Owners Manual for HDG-Series Griddles
SCREW
INTO FRAME
TURN TO
ADJUST
FOR
HEIGHT
IL2284