Built-In Hotplate Use and Care Manual

WARRANTY xi

SPECIFICATIONS 1

FEATURES & OPERATING CONTROLS 2

PRECAUTIONS & GENERAL INFORMATION 3

AGENCY LISTING INFORMATION 3

INSTALLATION 4

OPERATION 5

CLEANING INSTRUCTIONS 5

EXPLODED VIEW AND PARTS LIST 6

PARTS & SERVICE 7

CUSTOMER SERVICE DATA 7

Thank You for purchasing this Wells Manufacturing Co. appliance.

Proper installation, professional operation and consistent maintenance of this appliance will ensure that it

gives you the very best performance and a long, economical service life.

This manual contains the information needed to properly install this appliance, and to use and care for the

appliance in a manner which will ensure its optimum performance.

TABLE OF CONTENTS

SPECIFICATIONS

INTRODUCTION

ELECTRICAL SPECIFICATIONS

MODEL VOLTS WATTS AMPS FIELD WIRING

H-006UL 120 VAC 1ø 70 0.6

2 wire (L1, Neutral) + Gnd

14 AWG Copper 90ºC

MINIMUM CLEARANCES REQUIRED

UNIT-TO-NEAREST SURFACE

BACK SIDE BOTTOM* FRONT**

25 mm

203 mm

2-1/4"

57"

* If storage is to be used beneath unit, a

baffle must be placed 8" beneath the

hotplate to prevent contact.

** Front of counter to cutout.

If control box is placed directly beneath the

hotplate, clearance may be 1".