Operating instructions

GRIDDLE
28
SV509 SvcManual WVOC-G136
GRIDDLE SECTION - SERVICING INSTRUCTIONS (continued)
SV502 SvcManual WVG-136(RW)
REPLACE HEATING ELEMENT(S)
1. Disconnect unit from electric power and allow to cool before
servicing.
2. Withdraw grease tray from unit. Empty grease into an appropriate
container.
3. Remove six screws from recessed lip of control panel. Remove
control panel from unit (including grease tray sleeve). Withdraw
thermostat bulbs from griddle plate.
IMPORTANT: Do not damage capilary tubes.
4. Griddle assembly is held in place by Wellslok fasteners. Twist
Wellsloks inward to release. Cut seal at top panel, then lift griddle
assembly from top of unit.
5. Remove bottom panel from griddle plate assembly.
6. Note and mark position of wiring on elements. Disconnect wiring
from elements.
7. Mark insulation for orientation. Fold insulation retainers to allow
insulation to be removed. Carefully lift insulation from griddle.
8. Remove element clamps as necessary. Replace element(s), then
reinstall clamps (refer to Clamping Diagram on page 27). Be sure
to use anti-sieze on element clamp studs.
9. Reinstall insulation. Reconnect wiring.
10. Apply fresh sealant to bottonedge of griddle assembly. Lower
assembly into unit, then secure by turning out Wellsloks. Apply a
thin bead of food-grade silicone completely around edge of
assembly to seal it to the top panel.
11. Reinsert thermobulbs, then reinstall control panel.
12, Reconnect unit to electric power and test for proper operation.
WARNING
HOT SURFACES
Griddle surface can be VERY
HOT and may cause severe
burns on contact.
CAUTION:
SHOCK HAZARD
Disconnect electric power before
servicing.
Wellslok Fastener
Power Lead Connection
NOTE:
Examine connectors for
condition. Replace any that are
burned, distorted or excessively
discolored.
IMPORTANT:
Do not cut, pinch, twist or kink
thermostat capillary tube. This
will render the thermostat
inoperable, and cannot be
repaired.
NUT
LEAD
JUMPER
(WHEN USED)
NUT
ELEMENT
BOTTOM OF TOP PANEL