Operating instructions

GRIDDLE
27
SV509 SvcManual WVOC-G136
SV502 SvcManual WVG-136(RW)
GRIDDLE SECTION - SERVICING INSTRUCTIONS
REPLACE THERMOSTAT
1. Disconnect unit from electric power and allow to cool before
servicing.
2. Withdraw grease tray from unit. Empty grease into an appropriate
container.
3. Remove six screws from recessed lip of control panel. Remove
control panel from unit.
4. Remove griddle control knob by pulling straight off.
5. Note position of wires on thermostat. Disconnect wires, then
remove thermostat from control panel. Withdraw thermobulb from
thermowell in griddle element assembly.
IMPORTANT: Do not damage capilary tubes.
6. Insert thermobulb of new thermostat fully into thermowell. Be
careful that capillary tube is not damaged.
7. Verify that fishpaper insulator is properly in place, then attach new
thermostat to control panel. Reconnect wiring.
8. Reinstall control panel and grease tray.
9. Reconnect unit to electric power and test for proper operation.
REPLACE INDICATOR LIGHT
1. Remove control panel from unit as detailed above.
2. Disconnect wires from indicator. Remove indicator by collapsing
retaining ears with a flat-blade screwdriver. Withdraw indicator
from control panel.
3. Push new indicator into mounting hole until both retaining ears
snap into place. Reconnect wires.
4. Reassemble unit. reconnect to electric power and test for proper
operation.
WARNING
HOT SURFACES
Griddle surface can be VERY
HOT and may cause severe
burns on contact.
CAUTION:
SHOCK HAZARD
Disconnect electric power before
servicing.
IMPORTANT:
Do not cut, pinch, twist or kink
thermostat capillary tube. This
will render the thermostat
inoperable, and cannot be
repaired.