Operating instructions
OVEN
22
OVEN SECTION - SERVICING INSTRUCTIONS (continued)
REPLACE TEMPERATURE PROBE
• OLD-STYLE
1. Remove racks, rack support and fan baffle. Remove oven right
side panel.
2. Note positions of probe leads on controller, then disconnect leads.
NOTE: Examine glass sleeving for damage, scorching and
fraying. If unserviceable, replace sleeving while replacing the
probe.
Suggestion: Tie cord to the probe leads, and to the sleeving if it is
being replaced, to ease chasing the wires through the cabinet.
3. Remove screws holding the probe panel to the cavity "ceiling".
Carefully pry panel from cavity.
4. Remove temperature probe from panel. Remove probe leads, and
sleeving if necessary, through the cavity
5. Feed new probe leads (and sleeving) back through the cabinet.
Add a thin coating of anti-sieze to the probe threads and attach to
the probe panel.
6. Apply a thin bead of hi-temperatire silicone sealant to the edge of
the probe panel before reinstalling it in the cavity.
7. Connect probe leads to controller. Reconnect unit to electric
power and test for proper operation.
• NEW-STYLE
1. Remove oven right side panel.
2. Note positions of probe leads on controller, then disconnect leads.
3. Remove nuts flange holding probe to cabinet. Pull probe straight
out.
4. Reassemble in reverse order. Reconnect unit to electric power
and test for proper operation.
REPLACE HI-LIMIT THERMOSTAT
1. Remove racks, rack support and fan baffle. Remove oven right
side panel.
2. Remove screws holding the probe panel to the cavity "ceiling".
Carefully pry panel from cavity.
3. Disconnect wiring from hi-limit thermostat. Remove nuts holding
hi-limit bracket to panel.
4. Install new hi-limit. Reinstall bracket and connect wiring.
5. Apply a thin bead of hi-temperatire silicone sealant to the edge of
the probe panel before reinstalling it in the cavity.
7. Connect probe leads to controller. Reconnect unit to electric
power and test for proper operation.
CAUTION:
HOT SURFACE
Exposed surfaces can be hot to
the touch and may cause burns.
CAUTION:
SHOCK HAZARD
Multiple live electrical circuits are
present inside the control section
of the cabinet.
Disconnect power before
removing the side panel.
TEMP
PROBE
HI-LIMIT
THERMO
APPLY
SEALANT
HI-LIMIT THERMOSTAT
TEMP PROBE (OLD-STYLE)
TEMP PROBE (NEW-STYLE)
SV509 SvcManual WVOC-G136