Operating instructions

OVEN

REPLACE SPRING FOR FRYHEAD SUPPORT ROD OVEN SECTION - SERVICING INSTRUCTIONS (continued)

REPLACE PROXIMITY SWITCH

1. Remove lower door gasket, lower front panel and switch shield.

2. Disconnect wires and pull connectors through clamp.

3. Remove screws holding proximity switch to bracket.

4. Install new switch on bracket. As an initial adjustment, position the

switch as high and as far forward as it will go.

5. Thread leads through clamp and connect to existing terminals.

6. Reassemble switch shield, door gasket and front panel.

7. Test operation:

With power switch ON, fan should run when door is closed and

latched, and shut off when door is unlatched.

REPLACE ELEMENT

1. Remove right side panel, racks, rack supports and fan baffle.

2. Note position of wires on elements. Disconnect wires to

element(s) being replaced.

3. Loosen nuts holding element clamps to cabinet. Disassemble

element clamps.

4. Work elements out of clamps until element being replaced can be

removed.

5. Insert new element terminals through insulation and cover plates.

6. Reassemble elements in element clamps, making sure elements

are evenly spaced. Be sure to use anti-seize on screws.

7. Reinstall element assembly on cabinet. Be sure to use anti-seize

on weldstuds.

8. Reconnect wiring to element terminals.

9. Reinstall fan baffle, rack support, racks and right side panel.

CLAMP

ELEMENTS

COVER PLATES

& INSULATION

CAUTION:

HOT SURFACE

Exposed surfaces can be hot to

the touch and may cause burns.

CAUTION:

SHOCK HAZARD

Multiple live electrical circuits are

present inside the control section

of the cabinet.

Disconnect power before

removing the side panel.

BAFFLE & RACK SUPPORT

SV509 SvcManual WVOC-G136