Operating instructions

OVEN
19
REPLACE SPRING FOR FRYHEAD SUPPORT ROD OVEN SECTION - SERVICING INSTRUCTIONS (continued)
REPLACE CONVECTION OVEN CONTROLLER
1. Disconnect unit from electric power and allow to cool.
2. Remove time and temperature control knobs. Knobs pull straight off
shafts.
3. Note and mark wiring connected to rear of controller. Remove wiring.
4. Remove two nuts from studs at top of controller. Loosen two nuts on
studs at bottom. Lift controller out of cabinet.
5. Install shaft seals on time and temperature control shafts of
replacement controller. Install and connect new controller. Press
knobs on control shafts.
6. Reconnect to electric power and test for proper operation.
IMPORTANT:
If the drip shield is missing install moisture control kit p/n 67438.
If either switch boot is missing/damaged replace silicone boot p/n 63738.
REPLACE CONVECTION OVEN SWITCH (INDICATOR IS SIMILAR)
1. Disconnect unit from electric power and allow to cool.
2. Open the right side panel. Note and mark wiring connections on oven
controller. Remove wiring.
3. Using a small flat blade screwdriver and working from the back
(terminal) side of the switch, depress the mounting ears. At the same
time, press the switch toward the front of the control panel. Once
mounting ears are free of the panel, pull the switch out.
4. For switches, install a new silicone boot p/n 63738 before installing the
switch. Work the flange of new boot over the bezel of the switch,
making sure it is installed evenly.
Switches and indicators push into panel until they lock.
5. Reconnect wiring.
6. Reconnect unit to electric power and test for proper operation.
CAUTION:
HOT SURFACE
Exposed surfaces can be hot
to the touch and may cause
burns.
CAUTION:
SHOCK HAZARD
Disconnect power before
servicing the controller.
NOTE: When installing new
controller, check drip shield.
If it is not securely glued to the
cabinet panel, apply a thin
bead of food-grade silicone to
the notched side, then set it
over the two studs that secure
the top of the controller. When
properly installed, the drip
shield should be trapped
between the cabinet panel
and the controller.
NOTE: Shaft seals should be
installed so that the adhesive
faces are toward the controller,
and their long sides are
parallel to the long side of the
controller.
CONTROLLER
GASKET
DRIP
SHIELD
DRIP
SHIELD
GASKETS
SWITCH
BOOTS
CONTROLLER
REAR VIEW
SV509 SvcManual WVOC-G136